MODEL 2CM2

The 2CM2 controller has been designed to interface with pneumatic, hydraulic or electromechanical devices. This controller will interface with industry standard switches and sensors. All digital mobile controllers come with free programming software and a program template to facilitate fast control program development.

CONTROLLER FEATURES

Information

2 – Digital inputs 2 – High power outputs

PWM capable outputs

Description

Ideally suited to extreme automotive and industrial applications, static or mobile
Rugged heavy duty design with output short proof protection
PWM capable output at limited resolution
Integrated output and fault Tell-Tail LED’s providing feedback for diagnostic and operational monitoring
Digitally hardened against EMI and ESD
Card edge connector design for easy installation
Environmentally sealed for extended service life
Operating temperature – 40°C to +85°C
Operating voltage 9 to 30 VDC
Controller size of 4.5″ x 2.9″ x 0.9″
Lead-Free design
UL 94V-0 Flame Retardant Classification
SAE J1455 – Recommended environmental practices for electronic equipment design (Heavy duty trucks)
ASAE EP455 – Over voltage and reverse polarity protected
SAE J1113 – Recommended practices for shock, vibration and electromagnetic compatibility with immunity to conducted transients on power leads
2 Year Warranty

Electrical Parameters

Input resistance: 1.6K Ohms
Input voltage range: +/-30 VDC
Pulse input range: +/- 200V @ 15% D.C
Frequency input: 0 to 450Hz
Operating voltage: 9 VDC to 30 VDC
Quiescent current: 4mA
Operating Temperature: – 40°C to +85°C
Forced convection required above +55°C at maximum output
Environmental protection: Gelatinous silicone conformal
Output resistance: 0.038 Ohms @ 25°C
Output current: 5 Amps maximum continuous.
Outputs can be combined for high power output
Outputs are short circuit protected and open circuit monitored
Inductive load protected, repetitive 3 Amp maximum
Voltage swing: 0V to B+ (Battery Voltage)
PWM duty cycle: 0 to 100%
Reverse voltage protected
100% CMOS logic for greatest noise immunity

MCU Parameters

Microchip RISC PIC12F 8-bit Microcontroller
High performance Flash Microchip PIC12F508
4MHz = 1uS Fast execution time
512 Byte program memory
25 Byte RAM
Pseudo interrupt driven timing control
2 level deep hardware stack
Special MCU Features:
- Power-on reset (POR)
- Device reset timer (DRT)
- Watchdog timer (WDT)
- Power saving sleep mode